Mapal HTC Montage- Und Betriebsanleitung Seite 45

4 4 . . 3 3 T T o o o o l l s s a a n n d d m m a a t t e e r r i i a a l l s s r r e e q q u u i i r r e e d d
• Hex-wrench for the stop screw for axial or radial tool length adjustment.
• Hex-wrench for the clamping screw.
4 4 . . 4 4 T T e e c c h h n n i i c c a a l l d d a a t t a a
W W A A R R N N I I N N G G
F F a a i i l l u u r r e e t t o o o o b b s s e e r r v v e e t t h h e e t t e e c c h h n n i i c c a a l l d d a a t t a a a a n n d d m m a a x x . . o o p p e e r r a a t t i i n n g g s s p p e e e e d d s s ! !
Failure to observe the technical data can result in serious injury to the operator and in machine damage.
 Observe the technical data given in
 During clamping, screw in the clamping screw up to the stop, observing the specified minimum number of rotations.
 Observe the prescribed values for the minimum clamping depth.
 Observe the prescribed operating speed limits for the machine-side connection and the selected tool.
 Observe the maximum load limit for the machine-side connection in accordance with e.g. VDMA 34181 and the
selected tool.
 If irregularities occur during operation, do not use the HTC clamping chuck further for safety reasons and send it to
MAPAL for inspection or repair.
Montage- und Betriebsanleitung
Montage- und Betriebsanleitung
Installation and Operating Instructions
Installation and Operating Instructions
section 4.4
.
EN
EN
45
45