Mapal HTC Montage- Und Betriebsanleitung Seite 52

N N O O T T I I C C E E
D D a a m m a a g g e e c c a a u u s s e e d d b b y y t t o o o o l l l l e e n n g g t t h h a a d d j j u u s s t t m m e e n n t t w w i i t t h h c c l l a a m m p p e e d d t t o o o o l l ! !
EN
 Do not change the tool length adjustment as long as the tool is clamped.
EN
Adjusting tool length (axial)
W W A A R R N N I I N N G G
I I n n s s u u f f f f i i c c i i e e n n t t c c l l a a m m p p i i n n g g u u p p t t o o t t h h e e s s t t o o p p a a n n d d f f a a i i l l u u r r e e t t o o o o b b s s e e r r v v e e t t h h e e m m i i n n i i m m u u m m n n u u m m b b e e r r o o f f t t u u r r n n s s ! !
Insufficient clamping up to the stop and failure to observe the minimum number of rotations can cause the workpiece to
fly off like a projectile and cause serious injuries.
 During clamping, screw in the clamping screw up to the stop, observing the specified minimum number of rotations
section 4.4: Technical data
(see
52
52
I I N N F F O O R R M M A A T T I I O O N N
The stop screw for axial tool length adjustment is not secured to
prevent it from falling out. The specified adjusting range cannot be
exceeded.
Adjust the HTC clamping chuck to the tool length by turning the stop
screw for the axial tool length adjustment using an appropriate hex-
wrench with T-handle.
).
Montage- und Betriebsanleitung
Montage- und Betriebsanleitung
Installation and Operating Instructions
Installation and Operating Instructions