Climber CL7.13 Bedienungsanleitung Seite 13

Take care when positioning the belt guides; move them towards the belt, checking the deck at the
various height settings (fig 19).
HYDROSTATIC AXLE - ENGINE BELTS
These belts are self-adjusting and do not require any adjustment. Simply check the spring tension. To
replace the belts, release the tension spring (fig. 21).
BLADE ROTATION
Rotation is started and stopped using the switch no. 6, fig. 1.
When rotation is engaged , the engine must be running at medium rpm and the machine must not be in
the grass for cutting. Never start the blades with the engine at maximum rpm.
The machine is equipped with an electromagnetic clutch which also brakes the blade during
disengagement.
The blades are also disengaged automatically when the cutting height adjuster lever is moved to the
highest position.
CAUTION!! WHEN THE LEVER IS LOWERED THE BLADE STARTS UP AGAIN.
The blade must stop within 5 seconds, if this is not the case, adjust the 3 nuts of the electromagnetic
clutch, placing a 0.3 mm feeler gauge under the brake plate.
N.B. This operation must be carried out by an authorized after-sales service centre.
CHANGING THE BELTS
The movement is transmitted from the motor to the hydraulic transmission and to the blades by means of
two v-belts. Replace the belts as soon as they show signs of wear!
Their replacement and subsequent adjustment are fairly complex procedures and must be carried out by
an Authorised After-Sales Service Centre.
For cutting deck drive belt, the three belt guides beside the deck pulley have to be removed (fig. 19);
release the belt stretcher spring (Fig.20) and remove the belt guide (Fig.20).
ALWAYS USE ORIGINAL BELTS!
TRACTION RELEASE LEVER
The traction release device is located at the back of the machine (fig. 22); if the machine breaks down, to
allow it to be towed or moved by hand, move the lever to idle position (B, fig. 22). In the position (A)
shown in fig. 22 the machine is in working condition.
TROUBLE-SHOOTING:
CAUSE
– Battery not supplying power
Dashboard ON, but starter motor does not turn over with key in "AVV" (ON) pos.
– Battery not supplying enough power
– Start-up go-ahead not given
Climber Series 7/ Translation of the original instructions
PROBLEM
Dashboard OFF with key in "AVV." (ON) pos.
REMEDY
– Check connecting cables
– Recharge battery
– Change the fuse
– Recharge battery
– Travel lever in stop position
– Disengage blades
– Sit in the driver's seat
11