User's manual | RADICAL 4
Compatible speed-bar:
2B Light
Réf. : ACCELSOUPLELIGHTMPPL025
Speedbar assembly :
Regarding either side of the harness.
Pass the speedbar line through the front loop
1
2
Pass the line throught the pulley.
Finally, attach a hook to the line so that you can connect it to
3
your glider's speedbar.
Check the operation of the speedbar by simulating an acceleration.
4
i.e by sliding the line.
Be careful, make sure the speedbar is not set too short. It could be dangerous. When you are not using the speedbar,
the line should not be under tension at your risers.
Speed-bar system
3
2
ACCESSORIES ASSEMBLY
1
SUPAIR
| RADICAL 4 | page 12