Problems, Causes And Solutions - Wilo Star-E 15/1-3 Einbau- Und Betriebsanleitung

escape when the venti-
lation screw is opened
or shoot out under high
pressure.
scalding.
– Protect all
against the water released from
the unit,
– Carefully push pump shaft back
several times with screwdriver,
– Close ventilation screw,
– Re-open shut-off valve,
– Switch pump back on.
ATTENTION!
operating pressure, the pump is
liable to block when the screw plug
is open.
Depending on the ope-
rating condition of the
pump and/or installati-
on (fluid temperature)
the entire pump can
become
Avoid touching the
pump owing to the
risk of burning.
6.2 Setting the pump power
– Choose setting (see para.4.1).
– Preselect the pump capacity
(delivery head) according to
requirements using the regula-
ting knob (fig. 1, pos. 2).
– If the desired delivery head is
not known,
beginning with the setting 2 m.
Beware
electrical parts
Depending on the
intensity of
very hot.
we recommend
– If the heating output is inade-
quate, gradually increase the
setting.
– If the heating output is too high
of
or flow noise is heard, gradually
decrease the setting.
– Select, i.e. switch on or off, auto-
matic operation (autopilot) (see
para. 4.1).
7 Maintenance
the
8 Problems, Causes
and Solutions
Motor is switched on but fails to
run:
– Check electrical mains fusess,
– Check voltage of pump (observe
rating plate data),
– Pump blocked:
If the blockage is not rectified
automatically by the automatic
unblocking routine, employ the
manual
below.
– Switch off pump,
– Close shut-off valves either
side of pump and alloe pump
to cool down. Remove ventila-
tion screw. Check smooth run-
ning of pump by turning the
ENGLISH
Prior maintenance or
repair work switch off
the pump and secure
against unauthorized
switching.
procedure described
17