Options; Lock Local Parameter; Easy Teach Mode; Display Configuration - Balluff BAE SA-OH-061-UA-DP02 Betriebsanleitung

BAE SA-OH-061-UA-... / BAE SA-OH-062-IC-...
Photoelectric Sensors
7
Menu structure (continued)
7.5

Options

OPTIONS OPT Options
Lock Param PLC Lock OFF*, Lock ON
Conf.EasyT ETE Off*, 1-V-Teach
Display DIS
Brightness BRI
Orientation ORI
Stb Visib. STB always on, always off*, on w.touch
ShdwnTimer SHD Standby-Shutdown-Timer:
Fact.Reset DEF No*, Yes
* Factory Defaults
7.5.1

Lock Local Parameter

With Lock Local Parameter, the device can be locked,
except with Easy-Teach and Extern Teach.
7.5.2

Easy Teach Mode

This parameter determines which Teach Mode is called up
when the Easy Mode button is pressed (min. 3s).
Value
Off
1-V-Teach
Tab. 7-3: Options – Easy Teach Mode
7.5.3

Display Configuration

The display brightness and the reading direction of the
display can be set. Furthermore, it is possible to configure
how the display behaves in standby and after how long
after the last button press it goes into standby. In standby
mode the signal value is displayed if standby power is set
to "always on". In "on with touch mode" the display of the
signal value can also be reactivated with the lid closed by
covering the touch area.
Especially at high ambient temperatures it is recommen-
ded to set the standby power to "always off" or "on with
touch".
16 english
Display Settings
Low, Medium*, High
NoRotation*, 180°CW Rot.
5..60*..600 s
Meaning
Off
Single Value Teach

Display Brightness

– low
– medium
– high
Display Orientation
Value
NoRotation
180°CW Rot
Tab. 7-4: Options – Display Orientation
Display Standby Power
Value Meaning Description
Always always on OLED ist im Standby on
on
Always always off OLED ist im Standby off
off
On on with OLED is in standby off, is
w.touch touch switched on by covering the
Touch-PHT (for the same time
as configured in the display
shutdown timer)
Tab. 7-5: Options – Display Standy Power
Display Shutdown Timer
ShdwnTimer: Time [in s] after which the display goes into
standby: 5 to 600s
7.5.4

Reset Factory Settings

Reset all parameters and device settings to default settings.
Meaning
No rotation
180° CW