Operation; Menu Structure - EuroLite LED PLL-704 3200K Panel Bedienungsanleitung

OPERATION

After connecting the device to the mains it is ready for operation. The display indicates the last operating
mode. The operating modes can be selected by means of the display and the control buttons. All settings
remain stored even if the device is disconnected from the mains. The device can be operated in stand-alone
mode via the control board and the EUROLITE IR-7 remote control or in DMX-controlled mode via any
commercial DMX controller as well as wireless via QuickDMX with the optional available EUROLITE
QuickDMX USB Wireless Transmitter/Receiver.

Menu structure

Mode
DMX mode
Brightness
Sound control
Running speed in
automatic and sound-
controlled mode
Microphone sensitivity for
sound control
White color setting
Dimmer
Strobe effect
Sound control silent scene
Behavior in case of
missing DMX signal
Slave mode
Potentiometer
PWM frequency (pulse-
width modulation)
Firmware version
Display
3CH
DMX 2CH
1CH
BRIGHTNE 01-10
SOUND SOUND
SPEED 01-09
SENSITIV 01-09
COLOR W:000-255
DIMMING 001-100
FLASH 000-100
SILENT
Blackout
Hold
DMX LOST
Brightne
SLAVE Slave
POTENTIO
PWM freq 900-25kHz
Version
26/32
d001-512 3-channel mode and start address
d001-512 2-channel mode and start address
d001-512 1-channel mode and start address
Constant lighting of the set
brightness
Sound program
Program running speed
slow > fast
Microphone sensitivity
low > high
White 0-100%
Total brightness
dark > bright
Strobe effect
slow > fast
on LEDs off if there is no music signal
LEDs remain on if there is no music
oFF
signal
LEDs switched off
Most recent DMX value is held
Full All LEDs light at 100% brightness
Last selected brightness (01-10)
Slave mode
Switching on the manual rotary
on
control
Switching off the manual rotary
oFF
control
PWM frequency (pulse-width
modulation)
Vx.x Firmware version number
Function
00137991, Version 1.0