Stand-Alone Mode - EuroLite LED PLL-704 3200K Panel Bedienungsanleitung

Stand-alone mode

Brightness
In the BRIGHTNE mode the device will constantly in the set brightness.
1 Press the MENU button so many times until BRIGHTNE is indicated in the display. Confirm with the
ENTER button.
2 Use the buttons UP and DOWN to adjust the desired brightness (01-10). Confirm with the ENTER
button.
Sound control
Via the integrated microphone the unit can perfectly reproduce the show programs to the rhythm of the
music (sufficient bass provided).
1 Press the MENU button so many times until SOUND is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the desired show program. Confirm with the ENTER
button.
2 Press the MENU button so many times until SPEED is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to adjust the running speed of the program from 01 (slow) to 09
(fast). Confirm with the ENTER button.
3 Press the MENU button so many times until SENSITIV is indicated in the display. Confirm with the
ENTER button. Use the buttons UP and DOWN to Adjust the microphone sensitivity to the volume of the
music (01 = low, 09 = high).
4 If you enable the silent scene mode (on setting) in menu item SILENT, the LEDs will be switched off if
the volume is too low or if there is no sufficient bass beat. If you disable this mode (off setting) the LEDs
remain on during periods without music.
White color setting
In the color mode COLOR, the LEDs can be adjusted for brightness. The device will constantly emit the color
adjusted.
1 Press the MENU so many times until COLOR is indicated in the display. Confirm with the ENTER button.
2 Now the display indicates the letter "W" for white color and the corresponding brightness value. Use the
buttons UP and DOWN to adjust the desired brightness. Confirm with the ENTER button.
Total brightness
Menu DIMMING allows adjusting the total brightness for all stand-alone operating modes.
1 Press the MENU button so many times until DIMMING is indicated in the display. Confirm with the
ENTER button.
2 Use the buttons UP and DOWN to adjust the desired brightness (001 = dark, 100 = bright). Confirm with
the ENTER button.
Strobe effect
In FLASH mode the speed for strobe effect can be set.
1 Press the MENU button so many times until FLASH is indicated in the display Confirm with the ENTER
2 Use the buttons UP and DOWN to adjust the desired speed (000-100). Confirm with the ENTER button.
Behavior at missing DMX-signal
In DMX lost mode the program offers different options when no DMX signal is received.
1 Press the MENU button repeatedly until the display shows the DMX lost menu. Confirm with the ENTER
button.
2 Select the desired program with the UP and DOWN buttons (see menu structure). Confirm with the
ENTER button.
27/32 00137991, Version 1.0