Setting The Inputs Manually (Simulation) - Doepke DSU 8plus Montage- Und Bedienungsanleitung

All manuals and user guides at all-guides.com

6. Setting the inputs manually (simulation)

The DSU 8plus allows you to simulate input signals on the bus. This
means that you can manipulate the values that are sent over the bus
even when no signals are present on the inputs.
Proceed as follows in order to simulate inputs:
� O p e r a t i o n
①
1.
A l l
2.
�
①
I n p .
3.
�
①
E x i t
�
4.
①
Selection
M a n u a l
② ③
i n p u t s
o n o f f
② ③
I 1 a d d r .
o n o f f
② ③
m e n u ?
O K
② ③
» Select the menu item
indicated alongside
�
④ by pressing ① or ④.
» Skip to the submenu
by pressing ② or ③
» By pressing ② or ③ you can
then change the values of all
the inputs simultaneously.
» Quit manual operation by
* �
④
pressing ①, pressing ④
enables you to operate
inputs individually.
» Press ① or ④ to select the
input whose value you want
to change. Its current status
A 1
is indicated by an asterisk (*).
* �
» By pressing ② or ③ you can
④
then change the status of the
input that is output on the
bus side.
» To quit manual operation,
press ① or ④ to select the
menu item indicated along-
�
side�
④
» Pressing ② or ③ quits
manual operation.
DE EN
Description
27