inshape 2500 Gebrauchsanweisung Seite 70

Adjustment
Step 1:
Unplug the treadmill and remove the cover
from the motor.
Step 2:
Undo the 4 screws and adjust the threaded
rod using a 6 mm Allen key. If you can run
the motor belt more than 120 degrees
backwards, it is too loose. It must be
tightened. If you can only run the motor belt
around 60 degrees backwards, it is tightened
correctly. It must not be adjusted.
Step 3:
Retighten the motor and replace the cover
over the motor.
Adjusting the treadmill
Place the treadmill on a flat surface. Allow
the treadmill to run at a speed of 6-8 kph and
check if it is pulling to one side.
If the treadmill is pulling to the right, remove
the dead-man's switch and turn off the
treadmill. Turn the right adjustment screw
1/4 revolution clockwise, restart the treadmill
and check if it is now running straight.
Repeat the above until the treadmill is
running dead straight and in the middle.
See figure A.
If the treadmill is pulling to the left, remove
the dead-man's switch and turn off the
treadmill. Turn the left adjustment screw 1/4
revolution clockwise, restart the treadmill
and check if it is now running straight.
Repeat the above until the treadmill is
running dead straight and in the middle.
See figure B.
70
All manuals and user guides at all-guides.com
The treadmill will gradually become looser
over time. Tighten the treadmill by turning
both adjustment screws 1/4 revolution
clockwise and restart the treadmill.
Stand on the treadmill and check if it is
tight enough. Repeat the above until the
treadmill is tightened sufficiently.
See figure C.