Error Codes - inshape 2500 Gebrauchsanweisung

Error codes

Error Description
code
E1 Communication fault.
The treadmill stops and cannot be
restarted. The computer beeps 3
times. The control unit and computer
do not communicate correctly after
start.
E2 Motor faultjl.
E3 Speed is not registered by the
wireless sensor for more than 3
seconds.
E4 AutomaticAdjustment of the incline
does not work correctly.
E5 Excess voltage protection has tripped. Wait 10 seconds and restart the
E6 Self-check fault.
E7 EEPROM fault.
68
All manuals and user guides at all-guides.com
Troubleshooting
Check that the cables between the
control unit and computer are correctly
connected.
Check the cable to the treadmill's motor.
Check the cable to the treadmill's
motor, the plug for the sensor and the
control unit.
Check the cable for the incline motor
and the power cord.
treadmill.
Check that the voltage and frequency of
your power source are correct.
If the treadmill cannot start and motor
or electrical components smell burned,
the affected parts need to be replaced.
Replace thecontrol unit.
Replace the control unit.