Hoses Of The Dosing Pump - swim-tec CL2 Deluxe WiFi 1,6 l/h Bedienungsanleitung

Rx probe
The Rx probe is checked using the buffer solution Rx 475 mV. If the deviation of the
measure value is too large (40 mV), the electrode must be replaced. Caution: Rx
probes have been end-calibrated at the factory.
5.3

Hoses of the dosing pump

Careful: The rotating rotor may catch fingers! Before carrying out
any work on the pump, disconnect the voltage and secure to prevent
it from being switched back on!
Caution: Do not touch the motor directly after operation! First allow
the motor to cool down!
Protect yourself from the dosing medium! Ensure that the system is
not pressurised!
Note: Hoses are consumables!
The hoses of the dosing pump must be replaced annually, earlier if worn. To do this,
only use original replacement hoses. These can be obtained from your specialist pool
dealer.
The following hoses may be used:
701007 Replacement
sodium hypochlorite (chlorine bleach) [NaOCl] up to 12%
Hydrogen peroxide (active oxygen) [H2O2] up to 30%
Sulphuric acid [H2SO4] up to 30%
Hydrochloric acid [HCL] up to 38%
Not suitable for pH elevators (sodium hydroxide) [NaOH]
701005 Replacement
sodium hydroxide [NaOH] up to 30%
Sodium hypochlorite (chlorine bleach) [NaOCl] up to 12%
Hydrogen peroxide (active oxygen) [H2O2] up to 30%
Sulphuric acid [H2SO4] up to 30%
Conditionally suitable for hydrochloric acid [HCL]
Note: Dosing systems are supplied from the factory with Pharmed hoses.
The hose material must be coordinated for the water care products
and must be changed if necessary.
hose VITON for
hose PHARMED
54
0.4 – 2.4
for 0.4 – 2.4
l/h, suitable for
l/h, suitable for