Wall Installation; Maintenance Notes - swim-tec CL2 Deluxe WiFi 1,6 l/h Bedienungsanleitung

4.2 Wall installation

The control unit is attached to the wall using the enclosed screw bolts.
Attention should be paid to ensure that the suction pipe of the dosing pump is kept as
short as possible. The storage containers are thus placed directly underneath the device.
The suction lance for container extraction is screwed into the canister and connected to
the regulation device using the pin.
Warning:
The suction lance must be positioned in accordance with the size of
the pool to ensure that overdosing is not possible in the event that
the switching relay fails. It must be ensured that the base of the
suction lance is always located the appropriate distance below the
container level, this means that when the canister is full, the suction
lance may not be pushed down to the base of the canister.
The inoculation locations for pH and disinfection are installed in accordance with the
diagram. The test water pipe is to be connected to the flow cell in accordance with the
diagram. Mains cable and temperature sensor are already electrically connected within
the control unit.
5

Maintenance notes

In order to ensure trouble-free operation of the dosing system, regular
maintenance by a trained specialist is required. The manufacturer and the
installation company cannot be held liable in the event of damages caused by
a lack of maintenance.
Warning note:
All mains connections must be disconnect prior to starting any
maintenance work.
The filter sand must be change regularly in accordance with the instructions from the
manufacturer. Not carrying out this maintenance task may influence the trouble-free
operation of the dosing system. The filter chamber must be rinsed regularly to ensure
the trouble-free operation of the dosing system. The customer has been informed of
this.
51