Installation; Installation Diagram - swim-tec CL2 Deluxe WiFi 1,6 l/h Bedienungsanleitung

4

Installation

4.1 Installation diagram

10
4
2
(1) Test water
(2) Pump
(3) Filter
(4) Test water
For pools with an overflow, the test water is obtained directly from the pool,
approximately 20 cm below the surface of the water. Fibre filter and flow rate control
are obligatory.
The influence of the automatic water supply feed on the test water circuit must be
excluded. The supply feed may not be carried out when the dosing system is in
operation!
Cement grouting may influence the pH value if it has not been carried out correctly.
Mould and fungi in grouting are faults in the execution of the relevant work. A dosing
system is not able to counteract this.
Warning: No materials may be used in the pool that may be damaged in the event
of overdosing. The system manufacturer is excluded from liability in such instances!
1
3
11
(5) Heat exchanger
(6) Solar system
(7) Inoculation location pH
(8) Inoculation location disinfectant
50
5 6
(9) Feed nozzles
(10) Skimmer
(11) Bottom drain outlet
9
9
7 8
0.5