Installation Of Humidity Sensor In Pp 45 Rc; Commissioning - Maico PP 45 O Montageanleitung

9 Commissioning

8.10.3 Installation of humidity sensor in
PP 45 RC
In radio-controlled PP 45 RC units, the in-
tegrated humidity sensor is installed directly in
the ventilation unit.
1. Take off front cover of internal cover's hous-
ing. To do this, press on locking lever on un-
derside of housing and take off cover.
2. Loosen screw for circuit board cover, take off
circuit board cover.
NOTICE: No function if the humidity sensor is
installed incorrectly. Do not bend pins. Insert
sensor up to stop in bush.
3. Insert PP 45 HYI humidity sensor → Arrow.
4. Fit circuit board cover.
5. Attach front cover of internal housing at top in
two housing studs and swivel down until front
cover engages on locking lever.
6. Start up ventilation system and register humid-
ity sensor in service mode → Chapter
42
9 Commissioning
Basic settings on the room air control are under-
taken in service mode. If connected to RLS 45 K,
the commissioning software may also be used.
Switch on ventilation system as follows:
1. Ensure that all ventilation units and system
components are connected to the room air
controls.
2. Remove warning sign from fuse box and
switch on mains fuse. The ventilation units
start up in ventilation level 2.
3. Run function test.
4. Set the desired parameter values in Service
mode or using the commissioning software.
Basic settings can be made directly on the
RLS 45 O or RLS 45 K room air control unit.
To do this, select Service mode and set the
desired parameter value. Additional informa-
tion can be found in the online commissioning
instructions in the internet (download at
www.maico-ventilatoren.com)www.maico-ventil-
atoren.com). Here you can also download the
commissioning software for the RLS 45 K
control. This provides you with a wide range
of setting parameters for individual system
adjustments.