Front
OUTPUT SOCKETS
Rear
POWER SWITCH
INSTALLATION
Install the device on a plane surface.
DMX-512 control
The wires must not come into contact with each other, otherwise
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the device or one device with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first device in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first device in the DMX-chain with the DMX-input of the next device. Always
connect one output with the input of the next device until all devices are connected.
DMX INPUT SOCKET
POWER SUPPLY
the devices will not work at all, or will not work properly.
16/36
DMX OUTPUT SOCKET
FUSE
00056994.DOC, Version 1.1