Cembre B1350L-C Bedienungsanleitung Seite 6

WARNING
Do not use the tool for purposes other than those intended by Cembre.
The operator should concentrate on the work being performed and be careful to
maintain a balanced working position.
Before starting work on electrical equipment, please ensure that either there are
no live parts in the immediate working area or that precautions are taken for
working near live parts in accordance with EN50110-1.
Do not use this tool on or near energised conductors without proper personal
protective equipment. Failure to observe this warning could result in severe injury
or death.
The tool is unsuitable for continuous use and should be allowed to cool down fol-
lowing uninterrupted, successive crimping operations; for instance, having ex-
hausted a fully charged battery in one session, delay battery replacement for a
few minutes.
Protect the tool from rain and moisture. Water will damage the tool and battery.
Electro-hydraulic tools should not be operated in pouring rain.
2. INSTRUCTIONS FOR USE
IMPORTANT: Never pressurise the tool without inserting the dies, this could cause
damage to the head and the ram.
The part reference includes the following (Ref. to Fig. 8 page 45):
Hydraulic crimping tool.
Li-Ion rechargeable battery (2 pcs).
Battery charger (model depends on the tool version).
Shoulder strap.
Plastic carrying case.
USB cable (Ref. to § 5).
2.1) Preparation
The tool can be easily carried using either the handle or the shoulder strap attached to
ring (10) (Ref. to Fig. 6).
Before starting any work, check the battery charge (Ref. to § 2.8) and recharge if
necessary, following the instructions in the battery charger user manual.
6