Maintenance And Service; Maintenance And Cleaning - Bosch DWM 40 L PROFESSIONAL Bedienungsanleitung

All manuals and user guides at all-guides.com
OBJ_BUCH-167-002.book Page 17 Wednesday, October 18, 2006 1
Projecting/Transferring Angles
(see figure D)
Position the measuring tool with the
fold-out leg or with the base leg against
the workpiece. Adjust the required
angle with the other leg and project the
angle onto the workpiece.
When directly projecting a measured
angle onto a workpiece, pay attention
that the fold-out leg and the base leg
are not moved in relation to each other
and that the "HOLD" mode is not
switched on.
Measuring with Leg Extension
(see figure G–J)
The leg extension 4 (accessory) ena-
bles the measuring of angles when the
contact surface is shorter than the fold-
out leg 1.
Attach the leg extension 4 (see "Attach-
ing the Leg Extension"). Position the
base leg 6 and the leg extension plane
against or on the edges to be meas-
ured.
The reading of the angle w between
base leg and fold-out leg is indicated in
the display. The required angle v
between base leg and leg extension is
calculated as follows:
v = 180° – w
Examples for measuring with leg exten-
sion are shown in figures G to J on the
fold-out page.
Maintenance and
Service

Maintenance and Cleaning

For safe and proper working, always
keep the measuring tool clean.
Do not immerse the measuring tool into
water or other fluids.
Wipe off debris using a moist and soft
cloth. Do not use any cleaning agents
or solvents.
When the measuring tool is exposed to
rain for an extended period, its function
may be impaired. However, after com-
pletely drying off, the measuring tool is
ready for operation. No calibration is
required.
English | 17
1 609 929 J96 • 18.10.06