Gb D. Troubleshooting - Carson DRAGSTERBrushless-Regler Betriebsanleitung

d. Troubleshooting
Problem Cause
After power on, motor can't The connections between battery pack and ESC are not
work, no sound is emitted. correct.
After power on, motor can't Input voltage is abnormal, too high or too low.
work, but emits "beep-
beep-, beep-beep-" alert
tone.
(Every "beep-beep-" has a
time interval of 1 second )
After power on, motor can't Throttle signal is abnormal.
work, but emits "beep-,
beep-, beep-" alert tone.
(Every "beep-" has a time
interval of about 2 seconds)
The motor runs in the The wire connections between ESC and the motor need to
opposite direction. be changed.
The motor suddenly stops The throttle signal is lost. The ESC has entered the Low
running while in working Voltage Protection Mode.
state.
Random stop or restart or Some connections are not reliable. There is strong Electro -
irregular working state. Magnetic interference in flying field.
CARSON DRAGSTER Brushless-Sport „Water resistant Version" • 50 090 6158
Correction
Check the power connections.
Replace the connectors.
Check the voltage of the battery pack.
Check the transmitter and the receiver.
Check the wire of the throttle channe.
Swap any two wire connections between the
ESC and the motor.
Check the transmitter and the receiver.
Check the wire of the throttle channel.
Replace the battery pack.
Check all the connections: battery pack connections,
throttle signal wire, and motor connections, etc.
Reset the ESC to resume normal operation. If the
function could not resume, you might need to
move to another area to run the car.
GB
15