Troubleshooting - Carson X-Crawlee PRO Betriebsanleitung

Trouble Shooting
Problem
Model doesn´t move
Loss of control
Doesn´t run straight
Doesn´t stop
Doesn´t reverse
Running too slowly
500404067_X-CRAWLEE PRO_L1.indd 21
Downloaded from www.Manualslib.com
Cause
Transmitter or chassis power switch is not
"ON"
Polarity or battery type is wrong
Batteries have run down
Batteries have run down
Antenna is missing or not attached properly
R/C model using same band (frequency) is
nearby
Steering trim is not adjusted correctly
Front and rear wheel nuts are too lose
Throttle trim is not adjusted correctly
Throttle trim is not adjusted correctly
Wrong action
Batteries have run down
Motor has lost power
Rear wheel nuts are too loose
Dust or foreign objects are inside gears
manuals search engine
Correction
Switch power on receiver or transmitter
Check polarity and type of battery
Change batteries or charge them
Change batteries or charge them
Attach receiver antenna and/or transmitter
antenna screw tight
Run model in different area or change crystal
Make adjustment
Tighten wheel nuts
Make adjustment
Make adjustment
Control properly
Change batteries or charge them
Change to spare motor
Tighten wheel nuts
Turn the power switch "OFF" and clean out
gears
CARSON X-CRAWLEE PRO 500404067
G
21
25.02.14 09:23