Carson DRAGSTERBrushless-Regler Betriebsanleitung Seite 13

Note:
In the program process, the motor will emit "Beep" tone at the same
time when the LED is flashing.
If the "N" is bigger than the number "5", we use a long time flash and
long "Beep---" tone to represent "5", so it is easy to identify the items
of the big number.
Programmable Items list
Item
1. Running Mode
2. Drag BrakeForce
3. Low VoltageCut-Off
Threshold
4. Start Mode(Punch)
5. Maximum BrakeForce
6. MaximumReverse Force
7. Initial BrakeForce
8. Neutral Range
9. Timing
10. Over-heatProtection
Attention: The gray shaded texts in the above form are the
default settings.
1). Running Mode: With "Racing" mode, the car can go forward and
brake, but cannot go backward, this mode is suitable for competition;
"General" mode provides backward function, which is suitable for
training. The "Rock Crawler" mode is only used for rock crawler.
Note: "General" mode uses "Double-Click" method to make the car
go backward.
When you move the throttle stick from forward zone to backward
zone for the first time, the ESC begins to brake the motor, the motor
speeds down but it is still running, not completely stopped, so the
backward action is NOT happened now. When the throttle stick is
moved to the backward zone again (The 2nd "click"), if the motor
speed is slowed down to zero (i.e. stopped), the backward action
will be occurred. The "Double-Click" method can prevent mistakenly
reverse when the brake function is frequently used in steering.
With "Rock Crawler" mode, the reverse action will be happened
immediately when the throttle stick is moved to backward zone.
Please set the "Drag Brake Force" to 100% if you choose the "Rock
Crawler" mode.
2). Drag Brake Force: Set the amount of drag brake applied at neutral
throttle to simulate the slight braking effect of a neutral brushed
motor while coasting.
CARSON DRAGSTER Brushless-Sport „Water resistant Version" • 50 090 6158
For example, if the LED flashes as the following:
1. „A long time flash + a short time flash"
2. „A long time flash + 2 short time flash"
3. „A long time flash + 3 short time flash"
......
And so on.
1 2 3
Racing General Rock
Crawler
0% 5% 10%
Non- 3.1V/Cell 3.3V/Cell
Protection
Level 1 Level 2 Level 3
(Soft)
25% 50% 75%
25% 50% 75%
Drag 0% 20%
Brake-
Force
6% 9% 12%
(Eng) (Normal) (Wide)
0.00° 3.75° 7.50°
Enable Disable
3). Low Voltage Cut-Off: The function is mainly to prevent the lithium
battery pack from over discharging. When using lithium battery pack,
please set the suitable value for low-voltage protection as your like.
The ESC monitors the battery's voltage at any time, if the voltage is
lower than the threshold, the output power will be reduced to 50% in
2 seconds. Please drive and stop the car at the side of the racing track
as soon as possible, the ESC will completely cut off the output power
in 10 seconds.
4). Start Mode (Also called "Punch"): Select from "Level 1 (Soft)" to
"Level 9 (Very aggressive)" start mode as your like. Please note that
if you choose "Level 7" to "Level 9", you'd better use good quality
battery pack with powerful discharge ability, otherwise these modes
cannot get the bursting start effect as you want.
If the motor cannot run smoothly (the motor is trembling), it may
caused by the weak discharge ability of the battery pack, please
choose a better battery or increase the gear rate.
5). Maximum Brake Force: The ESC provides proportional brake
function. The brake force is related to the position of the throttle
stick. Maximum brake force refers to the force when the throttle stick
is located at the top point of the backward zone. A very large brake
force can shorten the brake time, but it may damage the gears.
(Motor sounds "Beep---Beep") = the No. 6 item
(Motor sounds "Beep---BeepBeep") = the No. 7 item
(Motor sounds "Beep---BeepBeepBeep") = the No. 8 item
Programmable Value
4 5 6
20% 40% 60%
3.5V/Cell 3.7V/Cell 3.9V/Cell
Level 4 Level 5 Level 6
100%
100%
40%
11.25° 15° 18.75°
7 8 9
80% 100%
Level 7 Level 8 Level 9
(Very
Aggresive)
22.50° 26.25°
13
GB