Carson DRAGSTERBrushless-Regler Betriebsanleitung Seite 14

6). Maximum Reverse Force: Sets how much power will be applied in
the reverse direction. Different value makes different reverse speed.
7). Initial Brake Force: It is also called "minimum brake force", and
it refers to the force when the throttle stick is located at the initial
position of the backward zone. The default value is equal to the drag
brake force, so the brake effect can be very smooth.
8). Throttle Neutral Range: Please see the following illustrations to
adjust the neutral range as your like.
GB
Forward
zone
End point of
forward direction
Reset All Items To Default Values
At any time when the throttle is located in neutral zone (except in the
throttle calibration or parameters program process), hold the "SET"
key for over 3 seconds, the red LED and green LED will flash at the
same time , which means each programmable item has be reset to its
default value.
14 CARSON DRAGSTER Brushless-Sport „Water resistant Version" • 50 090 6158
3
End point of
backward direction
Brake and
backward zone
Neutral
point
9). Timing: There are many differences among structures and parameters
of different brushless motors, so a fixed timing ESC is difficult to
compatible with all brushless motors. It is necessary to make the timing
value programmable. Please select the most suitable timing value
according to the motor you are just using. Generally, higher timing value
brings out higher power output, but the whole efficiency of the system
will be slightly lower down.
10). Over-Heat Protection: If the function is activated, the output power
will be cut-off when the temperature of the ESC is up to a factory preset
threshold for more than 5 seconds. When the protection happens, the
Green LED will flash.