Special Functions - Carrier 42QHP09E8S-1 Benutzerhandbuch

2.5 Special Functions

■ Compressor Delay
At start-up, a time delay of 3 ~ 5 minutes
protects the compressor.
■ Auto Defrost
Ice develops on the outdoor unit in heating
mode. To defrost this ice, the indoor fan stops
for a few minutes before heating continues.
■ Anti-cold
To avoid uncomfortable when the air
conditioner get into heating mode, the indoor
unit will preheat before the fan starts. This
delay should only last a few minutes.
■ Auto Restart
The unit will automatically restart after a power
interruption.
Previous user settings are all recovered.
■ Auto Leak Detection
When refrigerant leakage is detected, the unit
will display "EL C" code or flash LEDs [model
0
dependent].
■ Mildew Prevention*
This function keeps the indoor fan running in
low speed for 7 minutes after being turned
off by the user in cooling mode. Drying the
water droplets on the indoor heat exchanger
prevents mildew growth.
■ Turbo
The Turbo function makes the unit work extra
hard to reach your present temperature in the
shortest time possible.
Interrupting this process may scramble
the control logic.
To reverse this, briefly disconnect the
electrical supply.
■ WLAN Control*
With WLAN function, the unit can be controlled
either by remote controller or by your mobile
phone. Connect the WLAN module and
communication module with display board to
activate this function.
■ Louver Angle Memory*
When turning on your unit, the louver will
automatically resume its former angle.
■ Air Fresh function*
Innovated Air Magic technology, effectively
eliminates bacteria, virus, microbes,and other
harmful substances and refresh the air.
■ 8°C & 12°C heating function
When the air conditioner operates under
heating mode with the set temperature of
16°C, scrolls through operation mode as
follows by pressing temperature button twice
in one second: 8°C heating → 12°C heating →
Previous heating mode.
■ Self Cleaning*
Airborne bacteria use the moisture on the
indoor heat exchanger to grow. Regular
drying of the exchanger prevents this growth.
By simply pressing the "self clean" button,
the controller will automatically manage the
process.
[*] Model dependent.
10