Password Set Up - Konig Electronic SEC-ALARM210 Anleitung

cannot establish a steady communication with it. If this is the case, please install the sensor closer
to the control centre.
4. Replace the battery of the sensor in that zone if the control centre does not respond when the
sensor is activated within short range. If you have multiple sensors in a zone, you may test the
function of each sensor to identify which sensor is giving problems.
Erase sensors:
To erase a sensor from a zone, the control centre will erase all sensors in that zone. All sensors to a
particular zone will need to be synchronised again.
To erase a zone:
Step 1: Press and hold the "Learn Button" on the control centre. The unit will beep once.
Step 2: While holding the "Learn button", also press and hold the zone button to be erased. Hold both
buttons for 5 seconds until the control centre emits 2 beeps and the zone indicator flashes twice.
Step 3: Release all buttons.

Password set up:

The password is used for arming and disarming the control centre. The factory default password is 1 2
3 4. It is recommended to set up your own password by following the steps below.
Step 1: Press and hold the "Learn Button".
Step 2: While holding the "Learn Button", also press and hold the "Arm Button". Hold for 3 seconds
until you hear a long beep and the green power indicator flashes.
Step 3: Release both buttons. Enter the current password (with first use it is 1 2 3 4). You will hear
2 beeps.
Step 4: Enter the new 4-digit password, you will hear 2 beeps.
Step 5: Enter the new 4-digit password again to confirm. A long beep will sound and the green
indicator will stop flashing indicating your new password has been set.
8