Konig Electronic SEC-ALARM210 Anleitung Seite 7

Step 6:
A walk test should be performed after the motion detection
sensor has been mounted. Walk in the detected area, if motion
is detected, a red light inside the sensor will light up. If the red
light does not light up, motion has not been detected and you
may need to re-position the sensor. Ensure you test all the
locations that you would like the motion detection sensor to
cover.
Note:
-
Perform the walk test after the battery has
been inserted for more than one minute.
-
Before performing the walk test, the motion
detection sensor should not detect any
motion.
-
After motion is detected once, the motion
detection sensor will not be triggered
unless no motion is detected for
20 seconds. Wait for at least 20 seconds
during walk testing between 2 activations.
The motion detection sensor only detects
the first motion and again after 20 seconds.
If you experience false triggering, please pay attention to the following.
-
When installing the motion sensor, avoid placing it near heating or cooling devices. Air movement,
especially those caused by changes in temperature, may trigger the motion detection sensor and
cause false alarms. Please carefully test your motion detection sensor so that it will only be
triggered by wanted movement.
-
There is a jumper for sensitivity setting. You may change the sensitivity to low if you experience
false triggering. You will find the jumper setting on the left side of the test button. You can place the
small black plastic part on the pins with position 1 or 2. Position 1 is high sensitivity and position 2
is low sensitivity.
System status, sensor failure and low battery indication:
The control centre constantly monitors its sensors. If the control centre fails to communicate with any
sensors, the zone indicator will start flashing rapidly.
When sensor failure occurs, try the following:
1. Check if the sensor is located where it should be, and whether there is any physical damage to the
sensor.
2. If the failed sensor is not physically damaged, try to activate the sensor and see if the control
centre reacts to such activation.
3. If not, try to remove the sensor from its location, and bring it closer to the control centre and
activate the sensor. It is possible that the sensor is installed too far from the control centre and it
Detecting area in meters
7