Konig Electronic SEC-ALARM210 Anleitung Seite 3

Synchronising the door/window sensor(s) to the control centre:
Before proceeding, please remove the battery isolator from the sensor, and place the magnet beside
the transmitter (where the red marking is)
Press 3 seconds
Press the zone button
Step 3:
Activate the Door Window Sensor by separating the magnet from the sensor unit.
Insert 4 x AAA batteries for back-up during power
failure.
Step 1:
Press and hold the "Learn Button" on the
control centre for 3 seconds. Control centre
beeps once and you may release the "Learn
Button".
Long beep
Step 2:
Press the "Zone Button" (1, 2, 3, or 4) once for
what you want to program the sensor to. The
selected zone indicator will flash.
Zone indicator flashing
3