Konig Electronic SEC-ALARM210 Anleitung Seite 10

To arm the control centre in home mode:
Step 1: Enter the 4-digit password
Step 2: Press and hold the "Arm Button" for
3 seconds. The arm indicator will be ON
steady, indicating the control centre is now
armed in home mode.
Step 3: To disarm, enter the 4-digit password.
2) Arm Away
This setting is used when you leave home. By
arming the system in Away mode, you will have
45 seconds to leave after arming. After 45
seconds, all sensors in zones 1, 2, and 3 are
armed. Activating these sensors in Arm Away
mode will result in 30 seconds entry delay. If a
valid password is not entered during the 30
second entry delay, the alarm will sound.
To arm the Control Panel in Away mode:
Step 1: Enter the 4-digit Password
Step 2: Press the "Arm Button" twice. The Arm indicator will flash indicating the control centre is now
armed in Away mode.
Step 3: To disarm, enter the 4-digit Password.
Note: If a sensor in zone 4 is activated, it will not activate the alarm. Zone 4 is a dedicated alert zone, it
will sound alert beeping only.
Disarm alarm:
To disarm the system, enter the 4-digit password. The Arm indicator will be off if a valid password is
entered. If the alarm is activated, enter the 4-digit password to stop the alarm sound. After entering the
valid password, the entry delay or alarm will stop. The green power indicator will flash for 3 seconds,
which is normal.
Bypass zone alarm:
There may be occasions when you would like to temporarily prevent the sensors in a zone from
triggering the alarm. In this situation you can bypass a zone when arming the control centre. Once the
system is disarmed, the bypass setting will be removed.
Example:
You may want to leave a window open but to arm the system you can bypass the zone with the
window sensor and continue to arm the system. Without bypassing this zone, the control centre
cannot be armed.
To bypass a zone:
Step 1: Press and hold the "Zone Button" that you want to bypass for 3 seconds. After 3 seconds the
zone indicator will go steady, indicating this zone is set to bypass.
Step 2: Arm the system (Home or Away)
To remove the bypass, press and hold the zone button for 3 seconds, or disarm the system.
10