Konig Electronic SEC-ALARM210 Anleitung Seite 4

Magnet
button
Note:
You may program up to 4 sensors to one zone. Zone 4 is an alert zone; sensors in this zone are for
alert purpose ONLY and will not trigger the alarm.
Step 4:
After synchronising the sensor to the control centre, you may test the communication by placing the
magnet beside the transmitter (where the red marking is) and then removing the magnet from the
transmitter.
When the magnetic contact is closed,
the receiver will not beep.
Beeping will be according to the zone number (type of alert switch is set to alert) 1 beep for zone 1, 2
beeps for zone 2 etc, until the sensor is closed.
Note: If the type of alert switch is set to chime, the control centre will chime once for every signal
activated. If the switch is set to OFF, no audio alert will sound.
Step 5:
The sensor should be mounted on a door or window frame with double sided tape. The magnet should
be mounted on a door or window with double sided tape or screws. Make sure the magnet is aligned
with the red marking on the transmitter. If the König logo is upside down after mounting the sensor,
remove the front cover and rotate it so it is in the upright position.
Sensor
Separate the magnet
from the sensor
4
Control centre "long beep".
Zone indicator OFF
You will hear a long beep
and the zone indicator stops
flashing. The sensor is now
programmed to the control
When the magnetic contact is broken
(open), you will hear a beep and a zone
indicator will flash
centre