Blaupunkt Moby Blue S 0709E Bedienungsanleitung Seite 14

www.blaupunkt.com
MBS0709E, MBS12E
1) Take out the outer connector assembly and the exhaust pipe assembly, and remove
the plastic bags;
2) Insert the heat pipe assembly (the end of the exhaust joint) into the back panel vent
slot (push to the left) and complete the assembly (as shown in figure 1).
1.2 Installation of window sealing plate components
1) Half open the window,and mount the window sealing plate assembly to the window
(as shown in Fig.2 and Fig.3).Components can be placed in horizontal and vertical direction.
2) Pull various components of the window sealing plate assembly open, adjust their
opening distance to bring both ends of the assembly into contact with the window
frame, and fix various components of the assembly.1.2 Install the window sealing plate
assembly
Notes:
1) The flat end of the exhaust pipe joints must be snapped into place.
2) The pipe cannot be distorted nor has substantial turning (greater than 45 °). Keep the
ventilation of the exhaust pipe not blocked.
Figure 2 Figure 3
1.3 Install the body
1) Move the machine with installed heat pipe and fittings before the window, and the
distance between the body and walls or other objects shall be least 50 cm (as shown in Fig.4).
Figure 3
14