Dust/Chip Extraction - 3M 14253 Originalbetriebsanleitung

It is therefore important to observe the permissible rotational/circumferential speed on the label of the
abrasive tool.
Pull the plug out of the socket before carrying out any work on the power tool.
l
The machine head can be rotated in 90° increments. In this way, the on/off switch can be brought into a
more favourable handling position for particular applications, e.g. for left-handed tool users.
Completely unscrew the four screws. Rotate the machine head carefully, without removing it from the
housing, into the new position. Screw in and retighten the four screws.
The dust from materials such as lead paint, some types of wood, minerals and metal can be harmful to
human health. Touching or breathing in this dust can trigger allergic reactions and/or cause respiratory
illnesses in the user or in people in the near vicinity.
Certain dusts, such as oak or beech dust, are classified as carcinogenic, especially in conjunction with
wood treatment additives (chromate, wood preservative). Materials containing asbestos may only be ma-
chined by specialists.
– Use a dust extraction system that is suitable for the material wherever possible.
– Provide good ventilation at the workplace.
– It is advisable to wear a P2 filter class breathing mask.
The regulations on the material being machined that apply in the country of use must be observed.
Avoid dust accumulation at the workplace. Dust can easily ignite.
l
Operation
English
Pay attention to the mains voltage. The voltage of the power source must match the voltage spe-
l
cified on the rating plate of the power tool. Power tools marked with 230 V can also be operated
with 220 V.
Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal re-
l
sidual current of 30 mA or less.
When operating the power tool using a mobile generator that does not have sufficient reserve capacity
or an adequate voltage control system with inrush current boost converter, loss of performance or atyp-
ical behaviour may occur upon switch-on.
Please check the suitability of the power generator you are using, particularly with regard to the mains
voltage and frequency.
Switching on/off
English
To start the power tool, push the on/off switch (3) forward.
To lock the on/off switch (3) in position, push the on/off switch (3) forward and down until it clicks into
place.
1 609 92A 6BB • 16.3.21
max. [mm]
D b
115 7
125 7
115 –
125 –
Rotating the Machine Head (see figure A)

Dust/Chip Extraction

[mm]
d
22,2
22,2
–
–
English
Start-Up
English
[min -1 ] [m/s]
11500 80
11500 80
11500 80
11500 80
English
English | 17