Honda F660 Bedienungsanleitung Seite 36

1. Engine oil change
Change the oil when the engine is warm to assure rapid and complete
draining.
1. Remove the oil filler cap and the drain bolt to drain.
2. Tilt the tiller back to drain the crankcase completely.
3. Reinstall the drain bolt, refill with the recommended oil (see page
13 ), and reinstall the oil filler cap.
Oil capacity: 0.6 L (0.6 US qt, 0.5 lmp qt)
DRAIN BOLT
Wash your hands with soap and water after handling used oil.
2. Transmission oil change
1. Place the tiller on a level surface.
2. Remove the oil filler cap and drain bolt to drain.
3. Install the drain bolt. Fill the transmission with same oil as the
engine oil (see page
Oil capacity: 3.5 L (3.7 US qt, 3.1 lmp qt)
DRAIN BOLT
UPPER LIMIT
OIL FILLER CAP
13 ) up to the level. Install the oil filler cap.
OIL FILLER CAP
33