After An Accident - Lionelo Nico Bedienungsanleitung

Therefore, you must first remove the 5-point safety harness (see section 5.1) and
the backrest (see section 3.1).
Step 1: Place the base of the safety seat on the car seat in a way so that it rests
tightly against the vehicle backseat (fig. 26a).
Step 2: Place your child in the safety seat (fig. 26b).
Step 3: Fasten the 3-point car seat belt in a way so that the clasp is in the car buckle
on the other side of the safety seat.
Run the lap belt so that it passes across the child's chest. Make sure it is not twisted
and runs low enough, in order to support the pelvis.
When inserting the clasp in the buckle you will hear a „click" sound.
6. Maintenance
6.1 Pad installation / removal
•
Remove the 5-point safety harness (see section 5.1).
•
Tilt the backrest backwards so that it lays flat on the floor.
•
Now you can remove the backrest.
•
It is also possible to remove the pad of the headrest and (after loosening it)
the pad of the backrest.
•
After completion of the above steps you can remove the seat upholstery (by
pulling it forward). To install back all the parts of the pad please follow the above
steps in reverse order.
6.2 Cleaning the pad
When cleaning the pad (upholstery) use only neutral detergents and warm water.
Do not wash it in the washing machine, spin or tumble dry.

7. After an accident

An accident can cause damage to the safety seat. Therefore replace it immediately
with a new unit.
The pictures in this manual are for illustrative purposes only. Therefore, they may differ from the actual
EN
product.
‑ 14 ‑