Adjusting The Cutting Angle; Starting Operation - Bosch PCM 7 Originalbetriebsanleitung

OBJ_BUCH-880-004.book Page 30 Monday, July 19, 2010 11:56 AM
30 | English
Clamping the Workpiece (see figure F)
To ensure optimum working safety, the work-
piece must always be firmly clamped.
Do not saw workpieces that are too small to
clamp.
– Press the workpiece firmly against the
fence 6.
– Insert the material clamp 14 provided into
one of the holes 27 intended for it.
– Loosen the wing bolt 33 and adapt the mate-
rial clamp to the workpiece. Tighten the wing
bolt again.
– Firmly clamp the workpiece by turning the
threaded rod 34 in clockwise direction.
Loosening the Workpiece
– To release the material clamp, turn the
threaded rod 34 in anticlockwise direction.

Adjusting the Cutting Angle

When adjusting the cutting angle, never ac-
tuate the On/Off switch 19. Danger of injury
if the machine should accidentally start.
Before sawing, always tighten the clamping
lever 25. Otherwise the saw blade could be-
come jammed in the workpiece.
Adjusting Horizontal Mitre Angles
(see figure G)
The horizontal mitre angle can be set in the
range from 46° (left side) to 46° (right side).
– Release clamping lever 25, if tightened.
This allows the saw table to move freely.
– Turn the saw table 11 left or right by handle
9 until the angle indicator 35 indicates the
desired mitre angle.
– Tighten clamping lever 25 again.
For quick and precise setting of often used mi-
tre angles, the saw table 11 engages at the de-
tents of the following standard angles:
–45°/ –30°/ –22.5°/ –15°/
0°/ 15°/ 22.5°/ 30°/ 45°
1 609 929 U75 | (19.7.10)
Adjusting Vertical Bevel Angles (see figure H)
The vertical bevel angle can be set in the range
from 0° to 45°.
– Loosen the clamping lever 23.
– Tilt the tool arm by the handle 1 until the an-
gle indicator 36 indicates the desired bevel
angle.
– Hold the tool arm in this position and retight-
en the clamping lever 23.
For quick and precise setting of the standard
angles 0° und 45°, end stops are provided on
the housing.
– Loosen the clamping lever 23.
– For this, tilt the tool arm by the handle 1 to
the stop toward the right (0°) or to the stop
toward the left (45°).
– Retighten the clamping lever 23 again.

Starting Operation

Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Switching On (see figure I)
– To start the machine, press the On/Off
switch 19 and keep it pressed.
Note: For safety reasons, the On/Off switch 19
cannot be locked; it must remain pressed during
the entire operation.
The tool arm can only be guided downward
when pressing lever 3.
– For sawing, you must additionally press lever
3 in addition to actuating the On/Off switch.
Switching Off
– To switch off the machine, release the
On/Off switch 19.
Bosch Power Tools