Silvercrest SED 3.7 F2 Bedienungsanleitung Seite 75

5) Place the epilator perpendicular to the skin and, without exerting
any pressure, move it against the direction of the hair growth.
Thereby, the side with the speed switch
you. Do not make back and forth or circular movements.
Always start anew and pass over the body part to be epilated
several times, so that all of the hair is removed.
NOTICE
► It may be that the hair grows back after a few days. The
reason for this is that these hairs were too short to be
removed during the last epilation session.
6) When you are finished with the treatment, place the speed switch
to "0".
7) Clean the epilator head
and Care".
8) Replace the protective cap
│ GB │ MT
■ 72
must face towards
as described in the section "Cleaning
on the epilator head .
SED 3.7 F2