Blumfeldt Heat Guard Handbuch Seite 13

5
Pull the power cord gently out of the
base as much as possible. Fix the power
cord under the weighted base using the
supplied 4 x M4 nuts.
7
Raise or retract the top tube to the de-
sired height and tighten to the middle
tube by screwing knob down.
OPERATION
Connect the power cable to a 13 amp supply that is located in a safe, dry area.
The switch on the heater head is used to control the one heat setting.
0 OFF
Setting 1 900 W
Setting 2 1200 W
Setting 3 2100 W
6
Push the heater head onto the top tube
and fix it in position using the supplied
2 x M4*8 screws.
EN
13