Setting The Cutting Height; Battery; Maintenance - AL-KO EasyMow 700 Betriebsanleitung

Mowing tips
DANGER!
Danger of injury due to the cutting bla-
des!
Before all maintenance and care
jobs, always switch off the automatic
lawnmower using the [ON/OFF key].
Disconnect the transformer of the
base station from the mains.
Always wear work gloves when per-
forming maintenance and care jobs
on rotating and/or cutting tools!

SETTING THE CUTTING HEIGHT

Opening the cover
Pull item (2-6).
Setting the cutting height (10)
1 Open the lever up and turn it a quarter turn
clockwise in the direction of [lock symbol
opened].
The cutting height adjustment is unlo-
cked.
2 Pull the lever upwards.
Lawn cutting height is increased.
3 Push the lever downwards.
Lawn cutting height is reduced.
4 Then turn the lever a quarter turn anticlock-
wise in the direction of [lock symbol closed]
and engage.
Cutting height adjustment is locked.
5 Fold the lever down and close the cover (2-6).
The cutting height varies in the range
from 3 - 6 cm lawn height. It can be ad-
justed in five steps of 6 mm each.

BATTERY

The integrated battery is partially charged on
delivery. During normal operation, the battery
of the robotic lawn mower is regularly rechar-
ged.
When the battery charge reaches 0%, the ro-
botic lawn mower automatically returns to its
base station in order to charge the battery.
Interrupting charging does not damage
the battery.
The base station is equipped with an elec-
tronic control unit with a monitoring function.
This automatically terminates the charging
procedure when a 100% charge status is re-
ached.
456785_a
The battery status is shown on the display.
Make sure the charging contacts (10-1) of the
base station have adequate contact with the
contact surfaces (10-2) on the robotic lawn
mower.
The temperature range for charging should
be between 0 and 40 °C.
The built in protection circuit prevents the
battery from being charged at temperatures
above 45 °C, in order to prevent irreparable
damage to the battery.
If the operating time of the battery is reduced
in spite of it being fully charged, have the bat-
tery replaced by a new genuine battery. This
task should be carried out by a dealer, tech-
nician or service partner.
If the battery charge level has dropped be-
low the threshold set by the manufacturer as
a result of ageing or excessively long storage,
this means it cannot be recharged any lon-
ger. Have the battery and the monitoring elec-
tronic control unit checked by a dealer, tech-
nician or service partner, and renew it if ne-
cessary.
The battery status is shown on the display.
Check the battery status after about 3 months
by switching on the robotic lawn mower and
reading off the battery status. If necessary,
place it in the base station for charging.
In case of leakage of electrolyte must be rin-
sed with water / neutralizer. In case of contact
with eyes, so a doctor should be consulted.
The Li-ion battery contained is subject
to the requirements of hazardous sub-
stances regulations. The battery can be
transported on the road by private users
without being subject to additional requi-
rements. Only transport the battery if it
is undamaged. The battery must be pro-
tected against contact by other objects,
short circuit and inadvertent sliding. If
transported by third parties (e.g. haulage
company or transport by air) then it is ne-
cessary to comply with special require-
ments on the packaging and labelling.

MAINTENANCE

CAUTION!
Before performing any maintenance
STOP button!
35