Repair - AL-KO EasyMow 700 Betriebsanleitung

en
DANGER!
Danger of injury due to the cutting bla-
des!
During transport, always keep the cutting
blade plate facing away from your body.
Check robotic lawn mower, base station and
cable regularly for damage
Have damaged parts and batteries replaced
or repaired by a dealer, technician or service
partner
Transport
Only carry the robotic lawn mower by its deck.
Stop the robotic lawn mower using the [STOP
key] (13-2).
Switch off the robotic lawn mower using the
[ON/OFF key] (13-7).
DANGER!
Danger of injury due to the cutting bla-
des!
During transport, always keep the cutting
blade plate facing away from your body.
Cleaning
DANGER!
Danger of injury due to the cutting bla-
des!
During transport, always keep the cutting
blade plate facing away from your body.
1 Once a week, thoroughly clean the automatic
lawnmower with a hand brush or cloth.
Contamination can impair the function of
the machine if not removed.
2 Once a week, check the cutting blades (2-11)
for damage.
Damage to the electrical/electronic
system by incorrect cleaning!
Do not clean the automatic lawnmower
with a high-pressure cleaner or under
running water. Water penetration can
cause irreparable damage to the switch,
battery, motors and circuit boards.
Checking contacts
1 If the contact surfaces (12-2) on the automa-
tic lawnmower are contaminated, clean them
with a cloth.
36
Charring on the contact surfaces indica-
tes a poor charging contact.
Bend the springs on the base station
outwards (11-1).
Cleaning the chassis
1 Thoroughly clean grass catcher (13-5) and
guide (13-7) using a hand brush or a cloth.
Check the rollers can move freely
1 Once a week, thoroughly clean the areas
around the rollers (13-1) with a hand brush or
cloth.
2 Check the rollers (13-1) can move and steer
freely.
If the rollers (13-1) do not move freely,
they must be freed up or renewed.
Checking the base station
1 Disconnect the transformer mains plug.
2 Check the contacts (11-1) on the base station
for contamination and clean using a cloth if
necessary.
3 Push the contacts towards the base station
and release.
The contacts must spring back into the
initial position.
If the contacts do not spring back into the
initial position, have them checked by a
dealer, technician or service partner, and
renewed if necessary.
Storage
Before storage (winter) of the robotic lawn mower
following points should be noted:
Fully recharge the battery.
Off robotic lawn mower.
Clean robotic lawn mower.
Replace damaged cutting blade.
Robotic lawn mower store in a dry, frost-free
room.

REPAIR

Repair work is only allowed to be carried out by
expert workshops or our service centres.
Repair work is only permitted using original spare
parts.
Maintenance
Robotic lawn mower