Control Panel; Pin And Puk Code - AL-KO EasyMow 700 Betriebsanleitung

en
connections and cables are correctly seated; also
check them for damage.
Yellow LED (7-1)
lights up if the base station is connected to the
transformer and there is an electrical power
supply to the transformer.
flashes when the robotic lawn mower is char-
ging.
Green LED (7-2)
lights up when the boundary cable is laid cor-
rectly and the loop is OK.
flashes and then goes out if the loop of the
boundary cable is not OK.

CONTROL PANEL

3-1 The [LCD display] displays the current status or the selected menu.
Pressing the [STOP key] stops the robotic lawn mower and the cutting blades wit-
3-2
hin 2 seconds.
The [up and down arrow keys] are used for navigating in the menu and for chan-
3-3
ging values.
Press the [START/PAUSE key] to start the robotic lawn mower or interrupt opera-
3-4
tion. Caution – The machine starts automatically after about 30 minutes!
[Multifunction key right]
Confirm (call up a menu, confirm a change of values)
Next
3-5
Change
Activate / deactivate
Store / confirm
[Multifunction key left]
3-6 Cancel
Back (close menu, when entering values, go one value back)
3-7 The [ON/OFF key] is used for switching the robotic lawn mower on or off.
The [menu key] can be used for jumping back to the main menu from any sub-
3-8
menu.
The [HOME key] cancels the current mowing procedure. The robotic lawn mower
3-9 moves to its base station. The robotic lawn mower starts on the next day, with the
next mowing window.

PIN AND PUK CODE

Keep the PIN code and PUK code where they
cannot be accessed by unauthorised people.
The PIN code can be changed by the owner.
The PUK code can be stored by registering
on the following website:
http://robolinho.al-ko.com
30
The Li-ion battery contained is subject
to the requirements of hazardous sub-
stances regulations. The battery can be
transported on the road by private users
without being subject to additional requi-
rements. Only transport the battery if it
is undamaged. The battery must be pro-
tected against contact by other objects,
short circuit and inadvertent sliding. If
transported by third parties (e.g. haulage
company or transport by air) then it is ne-
cessary to comply with special require-
ments on the packaging and labelling.
If the PIN code is entered incorrectly three ti-
mes, it will be necessary to enter a PUK code.
If an incorrect PUK code is entered several
times, it is necessary to wait 24 hours before
a new entry can be made.
Assembly
Robotic lawn mower