Obey The Safety Instructions - ABB ACS580-04 Schnellinstallationsanleitung

EN – Quick installation guide (IEC)
Contents of this guide
This guide gives brief instructions on how to install the drive module in a 600 mm wide
enclosure.
For more detailed instructions, engineering guidelines, technical data and complete safety
instructions, see the hardware manual.

Obey the safety instructions

See figure A on page 97. If you ignore the instructions, injury or death, or damage to the
equipment can occur.
WARNING! Handle the drive module carefully. Open the support legs by pressing
each leg a little down and turning it aside (1, 2).
Do not tilt the drive module. It is heavy and its center of gravity is high. The
module will overturn from a sideways tilt of 5 degrees. Do not leave the module
unattended on a sloping floor.
To prevent the drive module from falling, attach its top lifting lugs with chains to the cabinet
frame before you push the module into the cabinet. Work carefully, preferably with help
from another person. Keep a constant pressure with one foot on the base of the module to
prevent the module from falling on its back.
WARNING! If you are not a qualified electrical professional, do not do installation
or maintenance work. Go through these steps before you begin any installation or
maintenance work.
1. Clearly identify the work location and equipment.
2. Disconnect all possible voltage sources.
•
Open the main disconnector of the drive enclosure.
•
Open the disconnector of the supply transformer. The main disconnecting device
in the drive enclosure does not disconnect the voltage from the AC input power
busbars of the drive enclosure.
•
Make sure that reconnection is not possible. Lock the disconnectors to the open
position and attach a warning notice to them. Follow the correct lock out and tag
out procedures.
•
Disconnect any external power sources from the control circuits before you touch
the control cables.
•
After you disconnect the drive, always wait for 5 minutes to let the intermediate
circuit capacitors discharge before you continue.
3. Protect any other energized parts in the work location against contact.
4. Take special precautions when close to bare conductors.
EN – Quick installation guide (IEC) 3
3AXD50000015469 D
EN
DA
DE
ES
FI
FR
FR
IT
FR
PL
PT
RU
SV
TR
ZH