Safety Instructions - ABB FEN-01 Kurzanleitung

2
Quick guide - FEN-01
Introduction
This manual contains the very basic information about installing the
FEN-01 TTL Encoder Interface. For complete documentation see
TTL Encoder Interface User's Manual (3AFE68784603

Safety instructions

WARNING! All electrical installation and maintenance work on the drive
must be carried out by qualified electricians.
The drive and adjoining equipment must be properly earthed.
Do not attempt any work on a powered drive. After switching off the
mains, always allow the intermediate circuit capacitors 5 minutes to
discharge before working on the frequency converter, the motor or the
motor cable. Lock out and tag out. Check (with a voltage tester) that the
drive is in fact discharged before beginning work.
These warnings are intended for all who work on the drive. Ignoring the
instructions can cause physical injury or death, or damage the
equipment.
For complete safety instructions see the drive manuals.
Compatibility
FEN-01 is compatible with the following encoders.
• TTL incremental encoder, 1...65535 pulses / rev, supports reference
mark
• TTL incremental encoder, 1...65535 pulses / rev, supports block
commutation and reference mark
Setting the supply voltage X301
WARNING! Selecting the wrong supply voltage may damage or break the
encoder.
Quick guide - FEN-01
FEN-01
[English]).