Placing Tool In Service - Ingersoll-Rand 104-A-Serie Bedienungsanleitung

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
LUBRICATION
Ingersoll- - Rand No. 50
Always use an air line lubricator with this tool.
We recommend the following Filter- - Lubricator- - Regulator
Unit:
For International - - No. C28- - C4- - FKG0
For USA - - No. C28- - 04- - FKG0- - 28
Before starting the tool and after each two or three
hours of operation, unless the air line lubricator is used,
pour approximately 1.5 cc of Ingersoll- - Rand No. 50 Oil
into (2).
After each 40 hours of operation, lubricate the Gearing.
Remove (22) by rotating it counterclockwise to remove
(23) and to expose the gearing. Coat (20) with a thin film
of Ingersoll- - Rand No. 28 Grease.
Periodically, inject several drops of Ingersoll- - Rand
No. 50 Oil between (23) and (29) to lubricate (28).
Model
104 Model A,
104 Model A- - EU
Tested in accordance with ANSI S5.1- - 1971 at free speed
H
♦ Tested to ISO8662- - 1 loaded with frictionbrake to 9 RPM
ISO3744
•
WARNING SYMBOL IDENTIFICATION
90 psig
(6.2bar/620kPa)

PLACING TOOL IN SERVICE

Ingersoll- - Rand No. 28
Ingersoll- - Rand No. 66
SPECIFICATIONS
Free Speed, Recommended
Torque Range
rpm ft.lb.
200 5 to 20
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by the
hose.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
To help promote durability and performance of the
Ratchet Head, periodically disassemble, degrease and
re- - lubricate the internal parts of the Ratchet Head
with Ingersoll- - Rand No. 66 Grease. If the Ratchet
Head "hangs up," it is usually due to lack of
lubrication.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
Nm Pressure
7 to 27
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________
FILTER
COMPRESSOR
(Dwg. TPD905- -1)
HSound Level
dB (A)
•Power
90.8 103.8
WARNING
♦Vibrations
Level
2
m/s
4.3