Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this
tool.
WARNING
Air powered tools can
vibrate in use. Vibration, re-
petitive motions or uncomfort-
able positions may be harmful
to your hands and arms. Stop
using any tool if discomfort,
tingling feeling or pain oc-
curs. Seek medical advice
before resuming use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
LUBRICATION
Ingersoll–Rand No. 10
Always use an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
For International – No. C28–C4–FKG0
Before starting the tool and after each two or three hours
of operation, unless the air line lubricator is used, detach the
air hose and inject about 2.5 cc of Ingersoll–Rand No. 10 Oil
into the air inlet.
After each forty–eight hours of operation, or as experience
indicates, inject about 1 cc of Ingersoll–Rand No. 28 Grease
into the gear case Grease Fitting.
After each forty–eight hours of operation, or as experience
indicates, inject about 1 cc of Ingersoll–Rand No. 66 Grease
into the angle head Grease Fitting.
WARNING LABEL IDENTIFICATION
90 psig
(6.2bar/620kPa)
PLACING TOOL IN SERVICE
Ingersoll–Rand No. 28
Ingersoll–Rand No. 66
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by the
hose.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pressure.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________
FILTER
COMPRESSOR
(Dwg. TPD905–1)
Werbung
Inhaltsverzeichnis
