Safety Notes; General - Honeywell aP Montage, Anschluss, Anleitung

10
1.

Safety notes

Read the instructions carefully and thoroughly before installing the device and putting it into operation.
They contain important information on assembly, programming and operation.
Only use the device:
- In accordance with regulations and
- When it is in a technically correct state
- In accordance with technical data.
The manufacturer is not responsible for damage that is caused by use not in accordance with
regulations.
Installation, programming as well as maintenance and repair work may only be carried out by
authorized, skilled personnel.
Soldering and connection work should only be carried out inside the entire system when it is de-
energized.
Soldering work should only be carried out using a temperature-controlled soldering bit that is
galvanically separated from the mains.
Observe the VDE safety instructions as well as the regulations of the local power supply company.
Do not use the device in a potentially explosive environment or in rooms with metal
or plastic decomposing vapours.
2.

General

The block switch serves as a switching element for intrusion detection central units.
The combination of a block switch and locking element (e.g. electromechanical blocking element)
provides an alternative solution to the block lock.
The block switch has a metal housing which renders it suitable for outdoor applications.
Safety devices and tamper monitoring:
- The housing can only be
- Cover contact
- Monitoring against drilling
The internal housing is equipped with an electromechanical monitoring against drilling which
triggers a tamper alarm when unauthorized persons attempt to penetrate the housing.
Mounting and Connection Instructions Block Switch
opened using the key .