Technical Data - BOMANN CB 2001 Bedienungsanleitung

Possible
Fault
Causes
When the
The machine has
main switch
no power supply.
is pressed the
machine does
not turn on.
The service door
is open.
Coffee grounds
collector (8) is
not correctly
inserted.
The water tank is
empty.
Percolation
The device is in
does not start.
steam extraction
mode.
The brew group
is not correctly
inserted.
In the coffee
preparation
cycle the noise The coffee beans
of the grinding
are used up.
mechanism be-
comes louder.
Hot water/steam
No hot water/
nozzle (14) is
no steam
blocked.
No coffee The water
comes out, but system has not
there is no error been fi lled with
message in the
the water from
display. the tank.
The coffee spout
(13) is blocked.
No coffee
comes out /
the coffee only
The water sys-
comes out
tem is blocked
slowly.
by lime.
Degree of grin-
ding too fi ne.
The heating
time becomes
longer, the The device is
warm water furred up.
quantity smal-
ler.
26
05-KAV 2936 GB 26
Remedy
Check the socket
with another The coffee is
device and insert not creamy
the mains plug
enough.
correctly.
Please close the
The milk is not
door.
foamed.
Insert the coffee
grounds collector
correctly.
Fill the water tank.
Turn the machine
The brew group
back to normal
becomes stuck
mode.
in the service
Insert the brew
chamber.
group correctly (see
section „Position of
the Drive Shaft").
Switch off the de-
vice and fi ll up the
container (2).
Unblock the
opening with a thin
needle.
Follow the instruc-
tions in the section
on „Initial Use"
carefully.
Switch off the
machine. Clean the
coffee spout and
Model:
the fi lter (diagram
Rated voltage/frequency:
B) in accordance
with the instruc-
Power consumption:
tions in the section
Protection class:
"Cleaning and
Maintenance".
Water tank:
Carry out descaling
Coffee bean container:
and cleaning.
Coffee grounds container:
If the problem per-
Dimensions
sists, set a coarser
(W x H x D):
degree of grinding
(see section „Set-
Weight:
ting the Degree of
Grinding").
This device has been tested according to all relevant
current CE guidelines, such as electromagnetic com-
patibility and low voltage directives, and has been
Start the descaling
constructed in accordance with the latest safety
programme.
regulations.
Subject to technical changes without prior notice!
Possible
Fault
Causes
The coffee mix-
ture used is not
suitable.
Degree of grin-
ding too coarse.
The milk is not
suitable.
The start and
end position of
the brew group
do not corres-
pond to the start
position of the
drive shaft.

Technical Data

approx. . 34,2 x 26,6 x 36,7 cm
Remedy
Try different coffee
mixtures.
Set to a fi ner de-
gree of grinding.
Check the fat
content. Use low
fat milk.
Switch the machine
on and off at least
fi ve times in a row.
Before switching
off each time allow
the adjustment
procedure of the
machine to fi nish -
loud clicking noises
are normal. Before
switching on again
each time please
check whether the
brew group has
come loose.
CB 2001 / CB 2002
230 V ~ 50 Hz
1300 W
Ι
1,4 l
250 g
0,6 l
approx. 9 kg
06.12.2004, 8:54:00 Uhr