IKEA SVALNA Bedienungsanleitung Seite 17

ENGLISH
Problem
There is too much frost and
ice.
There is too much frost and
ice.
There is too much frost and
ice.
There is too much frost and
ice.
There is too much frost and
ice.
Water flows on the rear plate
of the refrigerator.
There is too much condensed
water on the rear wall of the
refrigerator.
There is too much condensed
water on the rear wall of the
refrigerator.
There is too much condensed
water on the rear wall of the
refrigerator.
Water flows inside the refrig‐
erator.
Water flows inside the refrig‐
erator.
Water flows on the floor.
Water flows on the floor.
Water flows on the floor.
Possible cause
The gasket is deformed or
dirty.
Food products are not wrap‐
ped properly.
Temperature is set incorrect‐
ly.
Appliance is fully loaded and
is set to the lowest tempera‐
ture.
Temperature set in the appli‐
ance is too low and the ambi‐
ent temperature is too high.
During the automatic de‐
frosting process, frost melts
on the rear plate.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
Food products prevent the
water from flowing into the
water collector.
The water outlet is clogged.
The evaporative tray above
the compressor is not placed
below the melting water out‐
let.
Door was left open for a long
time.
The gasket is deformed or
damaged.
Solution
Refer to "Closing the door"
section.
Wrap the food products bet‐
ter.
Refer to "Control Panel"
chapter.
Set a higher temperature. Re‐
fer to "Control Panel" chap‐
ter.
Set a higher temperature. Re‐
fer to "Control Panel" chapter
and "Location" section.
This is correct.
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Make sure the tray is placed
below the melting water out‐
let.
Open the door only when
necessary.
Contact the Authorised Serv‐
ice Centre.
17