Cell Cycles" Menu; Information On The Cell Cycles - Nordcap SKF 12F GN 2/1 PLUS Bedienungsanweisung

7.9

"Cell cycles" menu

Any important information for optimal cycle operation is displayed via
IMPORTANT!
pop-up.
To access the Cell cycles menu, press the respective key on the "HOME" screen (see para.
7.5 "HOME" screen).
This menu consists of a series of preset cycles, which can all be edited according to the user's
needs.
7.9.1

Information on the cell cycles

Below is a list of useful information concerning the cycles:

The cell cycles are automatic and feature no "advanced" settings.

During the drying cycle, the door of the appliance must remain open resting on the
special support hook, otherwise the user will be informed by means of an acoustic
and visual warning on the panel.

If the appliance does not require a defrost cycle, the user will be informed by
means of a message on the panel.

The defrost and cell sanitisation cycles do not allow for the parameters to be
edited by the user.
APPLIANCE
Rev. 01 of 01/07/2019
Translation of the original instructions in Italian
"Cell cycles" menu
77
SOLL.
Fig. 7.12