Leak Testing - Sunred SFT15 Serie Handbuch

LEAK TEST
WARNING
A leak test must be performed annually and each time a cylinder is hooked up or if a part of the gas system is replaced.
WARNING
Never use an open flame to check for gas leaks. Be certain no sparks or open flames are in the area while you check for leaks. Sparks or
open flames will result in a fire or explosion, damage to property, serious bodily injury, or death..

LEAK TESTING

This must be done before initial use, annually,and whenever any gas Components are replaced or serviced. Do not
smoke while performing this test, and remove all sources of ignition. See Leak Testing Diagram for areas to check.
Turn all burner controls to the off position. Turn gas supply valve on.
Brush a half-and-half solution of liquid soap and water onto all joints and connections of the regulator, hose, mani-
folds and valves.
If the leak cannot be stopped, immediately shut off the gas supply, disconnect it,and have the patio heater inspected
by a certified gas installer or dealer. Do not use the patio heater until the leak has been corrected.
Hose / regulator connection
Regulator / Cylinder connection
EN
Case of the product may vary
18