Using The Appliance; Travel Lock - Philips HF8400 Bedienungsanleitung

EnglisH
8
When the massagers are fully charged, the charging light goes out.
,

using the appliance

Note: The massager shown in the figures is the female massager. The male massager has the same
buttons and functionalities.
Thoroughly clean the massagers before first use, after every use and when you use them on
another body area, to reduce the risk of infection (see chapter 'Cleaning').
1 Press any button to switch on the massager (Fig. 4).
The light ring goes on.
,
The massager starts operating in the default mode (mode 1) and at moderate vibration
,
speed.
Tip: We advise you to start in the default mode. You can gradually increase the vibration speed once you
are familiar with the options.
Note: If you feel uncomfortable during use, you can adjust the vibration speed. See step 3.
2 Press the mode selection button to adjust the vibration to your own preference (Fig. 5).
The massager has 4 vibration modes:
1 continuous vibration,
2 a pattern of pulses that rises and falls in intensity
3 a gentle, relaxing pulse
4 a more intense pulse
3 Press the increase or decrease button one or more times to adjust the vibration speed to
your own preference. (Fig. 6)
The massager has 5 speed levels.
4 You can hold the massager in different ways. Experiment to find the most comfortable way to
use the massager.
Tip: For suggestions, consult the welcome booklet.
Tip: You can also use the massager in combination with a water-based or silicone-based lubricant or
massage oil. Do not use scented and/or alcohol-based lubricants or massage oils, as they may cause
damage.
5 To switch off the massager, press and hold the mode selection button or the decrease button.

travel lock

It is possible to lock the massager, for example if you are going to travel. The travel lock prevents the
massager from being switched on by accident.
1 Switch off the massager.
2 Simultaneously press the increase button and the mode selection button to activate the
travel lock. (Fig. 7)
The light ring flashes once to indicate that the massager is locked.
,
3 To deactivate the travel lock, press the increase button and the mode selection button
simultaneously again.
The light ring flashes once to indicate that the massager is unlocked.
,
Note: When you place the locked massager in the plugged-in charging case and close the lid, the travel
lock is automatically deactivated.