Product Safety Information; Product Specifications - Ingersoll-Rand QP Serie Technische Produktdaten

Product Safety Information

Intended Use:
These tools are designed to install or remove threaded fasteners.
For additional information refer to Product Safety Information Manual Form 04585006.
Manuals can be downloaded from ingersollrandproducts.com

Product Specifications

Model(s)
QP1P28; QP1S28; QP1T28
QP1P20; QP1S20; QP1T20
QP1P15; QP1S15; QP1T15
QP1P10; QP1S10; QP1T10
QP1P05; QP1S05; QP1T05
QP1P02; QP1S02; QP1T02
† K = 3dB measurement uncertainty
pA
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16582967 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
80165939_ed4
Sound Level dB(A)
Free Speed
(ISO15744)
rpm † Pressure (L
2,800
2,000
1,500
1,000
500
250
WARNING
6. Thread size
7. Coupling
8. Safety Air Fuse
9. Oil
Vibration Level
(ISO28927)
)
p
77.2
76.2
77.2
78.1
75.9
77.2
EN
m/s²
<2.5
<2.5
<2.5
<2.5
<2.5
<2.5
EN-1