Inhaltsverzeichnis
Werbung
Step 4:
Mounting to the wall
NOTICE
L
A hand drill is required for this assembly step. Make sure that you use a suitable drilling
attachment. The contractor is not liable for any damage to the wall.
1.
Mount one wall bracket (F) to each side plank using two screws (G) each and tighten the
screws with the screwdriver.
2.
Place the wall bar to the desired position and mark the drill holes.
3.
Remove the wall bar from the wall and drill the required holes into the wall using a hand drill.
4.
Mount the wall bar to the wall on the cross beam (9) using two srews with anchor (J) each.
5.
Mount the wall bar to the wall on the wall brackets (F) using two screws with anchor (H)
each.
6.
Tighten the screws.
34
WALLBAR
Werbung
Inhaltsverzeichnis
Fehlerbehebung
